![]() 'C:\Program Files (x86)\National Instruments\LabVIEW 2020\examples\ULx'. ULx for NI LabVIEW 2.02 Library of virtual instruments (VIs) and example programs used. There are canned examples for 'ULx for NI LabVIEW' in the ULx subfolder for LabVIEW, i.e. InstaCal 6.26 Installation, calibration, and test utility. ![]() I dont understand what you mean by you only have 1 input wire. I dont think youll be able to run InstaCAL at the same time, but Im not sure on that. You will have to use the LabVIEW drivers that come with the Measurement Computing device. Instacal utility to register/interface with Measurement Computing I/O devices: icalsetup: 30 MB: Measurement Computing driver for A/D and D/a boards. Note: Only one application program that calls the Omegasoft driver can be running at a. HASP HASP4 Driver update for BeyondVR Games (Dark GREEN key) Connects to for download. InstaCals executable file, inscal32. Configure the device and click OK InstaCal stores hardware configuration settings in a configuration file which is read by other Omegasoft software when you run an application. Next, before launching LabVIEW, connect your MCC daq device (USB-TC) to the target system and then open MCCs InstaCal utility. Computing driver can be running at a time. Select the device on the PC Board List and then select Installā¼onfigure. Since your device does appear in the list, then close InstaCal and proceed to LabVIEW. It wont because it doesnt use the same basic device drivers as regular NI products do. Note: Only one application program that calls the Measurement. Next, TracerDAQ will install, click Next to proceed. Your daq device should appear in the list before you can use LabVIEW. Select Finish after completing the installation of InstaCal and the Measurement Computing Universal Library for Windows. InstaCal's executable file, 'inscal32.exe', is located in the 'C:\Program Files (x86)\Measurement Computing\DAQ' folder. Next, before launching LabVIEW, connect your MCC daq device (USB-TC) to the target system and then open MCC's InstaCal utility. Library, InstaCal, Measurement Computing Corporation, and the Measurement. Measurement Computing USB-201 has an analog input range of /- 10 Volts, aggregate sampling rate of 500 kS/s (if using 2 channels, total sampling rate would be 250 KS/s. they may distribute the necessary runtime files (Universal Library driver. LabVIEW must reside on the target system before 'ULx for NI LabVIEW' can be installed, but this requirement appears to be satisfied. The USB-204 DAQ Module has (8) single-ended analog inputs, (8) Individually-Configurable Digital I/O channels, (1) event Counter and (1) External Pacer I/O. Have you installed the current MCC DAQ software v6.73? If not, here is a link to download and then install the software, which allows a user to select 'ULx for NI LabVIEW' as part of the installation. Which version of LabVIEW do you have installed? At this time, 'ULx for NI LabVIEW' is not supported under LabVIEW 2022 only supported for LabVIEW 2010 to LabVIEW 2021.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |